INRAL SAND is a decorative spray paint with a natural desert sandstone effect. Suitable for surfaces such as metal, wood, plastic, polystyrene, stone, clay, ceramics, glass, paper and cardboard. Can be used both indoors and outdoors (away from rain and moisture) ;/Best used at +20°C, below +18°C drying times and paint properties will deteriorate. Contains no lead or chromium compounds and does not harm the ozone layer. DRYING TIME 1 hour
SURFACE: 2.2 m2
WORKING TEMPERATURE: +10°C … +25°C
Inral Sand effect paint
Decorative spray paint for a natural desert sandstone effect. Suitable for surfaces such as metal, wood, plastic, polystyrene, stone, clay, ceramics, glass, paper and cardboard. Can be used indoors and outdoors (away from rain and moisture).
- Quick drying
- Realistic sand effect
- Specially roughened surface
- Good coverage
- Can be used indoors and outdoors (away from rain and moisture)
Clean and degrease the surface. Shake the bottle vigorously for 1 minute. Spray distance 30 cm. Test the paint in an inconspicuous place to check compatibility and colour tone. For best results, it is recommended to use INRAL GROUND primer (for effect colours) or PLASTIC PRIMER primer (for coating plastic surfaces). Then apply SAND paint in 1-2 coats (with a break of 10-15 minutes). For long-lasting use, apply INRAL LACQUER acrylic lacquer on top (after 1 hour). The paint dries completely after 24 hours. When finished, turn the bottle upside down and clean the spray bottle by holding it for a few seconds.
Store upright in a dry place at +5°C to +25°C. Protect vials from direct sunlight and heat above 50°C. Transport temperature -15°C to +25°C, avoid direct sunlight and heat up to 50°C